The thermostat wires are not polarized; either wire can be con-. Always keep the thermostat's vents clean and unobstructed. Connect the thermostat wires to the line wires and to the load. Push any excess wire back into the electrical box. If necessary, before re-installing the front component, config-. Table of Contents.
Previous Page. Next Page. Aube technologies inc. Aube technologies thermostat installation instructions and owner's guide 5 pages. Aube technologies electric thermostat user manual 2 pages.
Aube technologies electronic thermostat user guide 2 pages. Temperature preset buttons Appears when the setpoint is displayed Time and day emperature Set the day Set the time Operating mode icons Program the schedule Temperature preset icons Skip a period Heating power Product has not been associated with this account, therefore your catalog will be empty. Please contact Customer Care for assistance. Online Learning. Independent Trainers. Industrial Combustion.
Industrial Combustion Training Videos. Traing and Development. Training and Development Portal. Case Studies. Competitive Cross-Reference. Control Valves Resources. Estimating Tools. NOTE: If no button is pressed for 60 seconds, the thermostat will automatically exit the programming mode. Power Outage In the event of a power outage, most settings are saved. Only the time must be re-adjusted if the power outage lasts more than 2 hours. The thermostat will return to the mode that was active prior to the power outage.
Under normal operation, the thermostat housing can Thermostat is hot. The measured temperature is below the LO is displayed. Heating is activated. The measured temperature is above the HI is displayed. Wrong temperature is The thermostat is exposed to air draft. Eliminate the draft. The thermostat was without power for Wrong time is displayed. Temperature does not Check that the thermostat is in Automatic change according to the mode.
Check the schedule and clock setprogrammed schedule. The thermal protection device on the Display disappears and heater is open. This can happen after a reappears after a few power failure or if the heater is obstructed minutes.
Display looks faded The heating system is less than the when heating is actirequired minimum load. This thermostat vated cannot be used below that rating.
Warranty Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and service, for a period of one 1 year from the date of purchase by the consumer.
If at any time during the warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it at Honeywell's option. If the product is defective, i return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it, or ii call Honeywell Customer Care at This warranty does not cover removal or reinstallation costs.
This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by damage which occurred while the product was in the possession of a consumer. Honeywell's sole responsibility shall be to repair or replace the product within the terms stated above. Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
0コメント