Page Operating The Display The signal source may come from any of the input blocks on the sides or bottom of the display. Select one of the Cable options if you are connecting directly to a cable TV wall outlet. Contact your cable service provider to find out which system is in use in your area. Cable or Cable-IRC will work with most systems. Page 22 Cycles through the sound enhancement options: Normal, Music, Speech, Jazz Club, Concert, or Movie When viewing digital TV, brings up a list of the channels you have viewed most When viewing analog TV, brings up the closed captioning menu, where you You can change video and audio settings, activate and configure closed captioning, select television channels, control access to mature programming, and configure other general display behavior.
Page Audio Auto Volume Turns automatic volume adjustment, used to compensate for program sound level variation, on and off. It contains the following menu items: Auto Scan When selected, automatically scans all television channels for valid signals and makes unavailable any channels with insufficient signal strength.
It contains the following menu items: Clock Display Turns the time display on and off. When on, the time shows in the top right corner of the display. Blocking a particular rating will automatically block all ratings above that level. Similarly, unblocking a rating will automatically unblock all ratings below that level.
The following settings are available: Brightness Sets the brightness of the display image. Contrast Sets the variation between light and dark colors. Page Closed Caption Dtv The factory-default password is ''.
Specific types of mature content listed across the top can be blocked for some of the ratings. Time Zone Selects the current time zone. All Reset Resets all digital TV settings to factory defaults.
Select Yes to reset all settings, No to cancel. Make sure the signal cable s are firmly connected. Check the TV signal. If using an antenna, adjust the position for better signal. If using cable or satellite TV, contact your service provider. Print page 1 Print document 40 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Setting Up the Display Connecting to a TV Signal Source Accessing the Connector Panel Connecting to Composite Video Output Devices You can use your new display as a television, in a home theater system, or even as a computer monitor.
With component, composite, and S-Video video inputs, you can connect numerous devices to your display, including Right To unpack the display: Set the box upright near the intended display The rear ventilation grid should be unobstructed, and the display should not be exposed to water or heat.
To access the jacks on the panel, remove the cover as shown below--rel; the two tabs to the right, then pull the cover out. S-Video uses four-wire cable to transmit video information. Two of the wires are used to transmit video. Because it splits the video signal into two components, S-Video generally provides Component video uses three RCA connections transmit video information.
Use this procedure only for video video formats i, i, i, and so on. See the previous section information on connecting Open the Displays panel and select the Display tab.
Select the desired resolution from the list. You can video and audio settings, activate and configure picture-in-picture PIP and closed ca select television channels, control access to mature programming, and configure The following is a list of all buttons on the remote and their functions: Button Function The menu structure varies depending on the selected signal source.
The table below gives the available options for each source. The V-Chip Block menu allows you to change the password and select which content should be blocked.
The information is displayed in a table, where 'U' means unblocked and 'B' means blocked. Cause Unclear or Make sure the signal cable s are firmly connected. If using an antenna, adjust the position for better signal.
0コメント